OMRI Listed for organic gardening

• For control of plant diseases in home gardens: vegetables, ornamental and fruit trees, shrubs, lawns, flowers, bedding plants, and potted ornamental plants
• Foliar Spray or Soil Drench
• For control of plant diseases in and around
  homes and home gardens: houseplants, tropical
  plants, vegetables, ornamental and fruit trees,
  shrubs, lawns, flowers, bedding plants, and
  indoor and outdoor potted ornamental plants
  
  

Active Ingredient:
Bacillus amyloliquefaciens strain D747*.............................. 98.85%
Other Ingredients:....................................................................... . 1.15%
Total: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100.00%
*Contains a minimum of 1x1010 colony-forming units (cfu) per milliliter

Spray application for control of powdery mildews, leaf spots,
anthracnose, gray mold, and other diseases affecting leaves,
flowers, fruit, and other above-ground plant parts of indoor
and outdoor potted plants, home garden plants, vegetables,
ornamental, fruit and nut trees, tropical plants, shrubs,
flowers and bedding plants: Mix 1 teaspoon of MONTEREY
COMPLETE DISEASE CONTROL BRAND per gallon of water
and apply directly to plants using a hand pump sprayer or other
suitable spray equipment. Spray just enough to wet all leaves and
fruit with minimal run-off or dripping. Total coverage depends on
the size of plants to be sprayed and the type of sprayer used.
Repeat as needed to maintain disease control, typically every 7-
10 days. If disease is prevalent or environmental conditions
such as high humidity favor disease outbreak, increase the mixing
rate to 1 tablespoon per gallon and shorten the interval between
sprays to every 3-7 days.
Drench application for control of diseases affecting plant
roots, tubers, or other parts of plants in contact with soil in
the home and home garden: Mix 1 teaspoon of MONTEREY
COMPLETE DISEASE CONTROL BRAND per gallon of water
and apply to the soil by one of the following methods:
For Potted Plants (Indoors or Outdoors)
• Apply in sufficient water to wet the entire root mass using a
watering can or tank-fed watering wand. Do not water plants
again until 24 hours after application. Alternatively, use a handpump or other sprayer to spray the mixture on the soil surface
in each pot, then immediately apply sufficient water to move the
product into the roots.
• Drench the roots of transplants with approx. 4 fluid ounces of the
mixture immediately before transplanting into pots or garden soil.
Allow to soak into the root ball before transplanting.

For Outdoor-Grown Plants:
• Use a watering can or sprayer to drench the soil in the
planting furrow or transplant hole immediately before planting
or transplanting. The amount of water required will depend on the
size of the hole or length of furrow.
• Alternatively, apply in the first watering after planting or
transplanting, either by mixing directly into the water at the rate
indicated above, or by spraying onto the soil surface at the base of
each plant and immediately watering in with a watering can, hose,
sprinkler, or other watering device.
MONTEREY COMPLETE DISEASE CONTROL BRAND can be
applied up to and including the day of harvest.
For application to lawns and other grass areas: Mix 1 teaspoon
of MONTEREY COMPLETE DISEASE CONTROL BRAND per
gallon of water and apply as a fine spray to the surface of the
lawn or grass area. Total amount of mix required will depend on
the type of sprayer used and area to be covered, but typically 2 to
5 gallons of spray mix may be required per 1,000 square feet of
lawn. MONTEREY COMPLETE DISEASE CONTROL BRAND can
be “watered in” for control of soilborne root and crown diseases by
thorough watering immediately after application either with sprinklers
or by spraying just before or during light rain.